Data

This section provides access to various datasets published by the Antarctic Ice Sheet ECV project.

Samples of the project's datasets are also available on the ESA Climate Office Open Data Portal.

Surface elevation changes (SECs)

Elevation measurement over Lake Vostok, East Antarctica from Sentinel-3A:

Surface elevation changes (SECs) of an ice sheet are directly linked to the atmospheric forcing and hence climate changes. The SEC reflects the vertical component of ice sheet mass balance. SEC is derived from satellite radar altimetry data, and therefore the product is the elevation change of the reflecting surface rather than the snow surface.

Thanks to a succession of ESA satellite missions starting with ERS-1 in 1992 and continuing with CryoSat-2 and the Sentinel-3 missions, satellite altimetry provides the longest unbroken record of ice sheet mass balance from all geodetic techniques. Altimeter measurements of elevation change are extremely precise, because they require only modest adjustments to account for sensor drift, changes in the satellite attitude, atmospheric attenuation, and movements of Earth's surface. The Antarctic_Ice_Sheet_cci+ project will produce a continuous monthly time series of surface elevation change measured using over 28 years of radar altimetry satellites including ERS-1, ERS-2, ENVISAT, CryoSat-2 ,Sentinel-3A and Sentinel-3B.

SEC products are hosted by CPOM: http://www.cpom.ucl.ac.uk/csopr/icesheets3/.

Ice Velocity

AIS Ice Velocity

There is ample evidence indicating ongoing large and rapid changes in the Antarctic Ice Sheet, including the break-up of several ice shelves, glacier acceleration, and thinning and retreating grounding lines. The changes led to an increased ice discharge and contributed to sea level rise. Mapping ice sheet velocity (IV) and temporal changes in flow velocity provide key information for investigating the dynamic response of glaciers and ice sheets to changing boundary environmental conditions.

In the Antarctic Ice Sheet CCI project, SAR images acquired by the Sentinel-1 mission are used to derive ice flow velocity in Antarctica. Sentinel-1 has provided the opportunity to derive the ice flow velocity of key ice streams and outlet glaciers in Antarctica on a regular basis. The continuous coverage currently includes most of the Antarctic Ice Sheet margin, allowing for the retrieval of dense time series of ice flow for major Antarctic outlet glaciers previously only seldom observed.

In the current phase of the project, the system for IV retrieval will be further adapted and improved to accommodate new user requirements, increase data coverage and temporal resolution, and prepare for upcoming new SAR satellite missions (e.g. ROSE-L, NISAR).

We also plan to exploit the existing archive of ice velocity data and study the feasibility of a new ECV product on ice velocity change (IVC), detailing the spatial distribution of changes in ice flow rate over specified time intervals. IVC is a fundamental ice sheet parameter which is key to detecting and investigating dynamic instabilities and to identifying temporal fluctuations and long-term trends thereby improving future predictions of ice flow in response to a changing climate.

IV products are provided on ENVEO CryoPortal and CEDA.

Grounding Line Location

The location of the transition where the ice resting on bedrock detaches and becomes a floating ice shelf is a critical parameter needed for calculations of the ice sheet mass budget, as well as for modelling ice ocean interactions, ice sheet dynamics, subglacial melt and oceanic tides. Due to its importance, the grounding line position is one of the key parameters of the ice sheets which have been derived from satellite observations within the project.

The retrieval of the grounding line position is based on the influence of the ocean tides on the floating ice which rests in hydrostatic equilibrium. Due to the fact that this tidal rise is absent on the grounded part of the glacier, a vertical deformation appears in the transition area.

GLL_image.png

The InSAR double differencing method (DInSAR) has been identified to be one of the most accurate techniques for locating the vertical tidal deformation of the ice sheet. At least two pairs of coherent repeat pass data sets must be combined in order to remove the common velocity component revealing the vertical component due to tidal motion. In practice the major limiting factor of this technique is the availability of data sets with sufficiently high InSAR coherence. Physical phenomena such as snow accumulation, drift or melting may significantly change the surface properties between the satellite passes and thus the backscatter behaviour which can lead to loss of phase coherence in the interferograms.

Antarctic_Ice_Sheet_cci+ project will continue the generation of GLL from recent Sentinel-1A/B acquisitions on selected key glaciers and thus extending the temporal extension of GLL datasets.

GLL products are provided on ENVEO CryoPortal: http://cryoportal.enveo.at/. Access to product downloads requires registration and login. There are different user levels (anonymous, external, partner & staff) that determine the permissions for reading and accessing the data.

Gravimetric Mass Balance

GMB_figure.png

The currently available Gravimetric Mass Balance (GMB) products are based on the GRACE (Gravity Recovery and Climate Experiment) satellite mission and respond to the high priority for mass balance parameters identified in the user survey.

The updated GMB products to be generated in the CCI+ extension of the AIS_cci project, will also include data from the follow-on mission GRACE-FO.

GRACE/GRACE-FO gravity observations have the advantage of their direct sensitivity to change in the total ice sheet mass, including fluctuations in snow and ice (rather than geometry changes) on an approximately monthly time resolution, though with intrinsic limits in spatial resolution.

GRACE was launched in March 2002 and ceased operation in October 2017, after more than 15 years in orbit. The GRACE- Follow-On mission was launched in May 2018 and ensures continuity with enhanced accuracy and resolution.

Two GMB products are provided: time series of monthly mass changes for individual drainage basins, and Gridded mass changes over the entire ice sheet.

The GMB basin product is provided in ASCII format, while the gridded product is available in various formats, such as ASCII, netcdf and GeoTiff.

GMB products are hosted by TU Dresden: https://data1.geo.tu-dresden.de/ais_gmb/. User-friendly functionalities allow users to interactively browse and explore both the GMB basin and the GMB gridded product.

Mass change time series for individual drainage basins can be displayed by selecting the basin of interest from a map. The time series plot allows us to zoom to a certain period and to query values for a specific monthly solution. The plot can be saved in raster (png) and vector (svg) format.

An animation of the monthly grid series is available to visualise the GMB gridded product. By selecting a particular month from the plot of the mass change time series for the entire AIS, the corresponding monthly grid is displayed.